IMO HD2-3.7A-43 - Page 172

HD2 Series Inverter Function Parameter List
-163-
Function
code
Name
Description
Default
value
Modify
motor 1
P04.45
Enable/disable IF
mode for
asynchronous
motor 2
0: Disabled
1: Enabled
0
◎
P04.46
Current setting in
IF mode for
asynchronous
motor 2
When IF control is adopted for asynchronous
motor 2, this parameter is used to set the output
current. The value is a percentage in relative to the
rated current of the motor.
Setting range: 0.0–200.0%
120.0%
○
P04.47
Proportional
coefficient in IF
mode for
asynchronous
motor 2
When IF control is adopted for asynchronous
motor 2, this parameter is used to set the
proportional coefficient of the output current
closed-loop control.
Setting range: 0–5000
650
○
P04.48
Integral
coefficient in IF
mode for
asynchronous
motor 2
When IF control is adopted for asynchronous
motor 2, this parameter is used to set the integral
coefficient of the output current closed-loop
control.
Setting range: 0–5000
350
○
P04.49
Starting
frequency point
for switching off
IF mode for
asynchronous
motor 2
0.00–P04.51
10.00Hz
○
P04.50
End frequency
point for
switching off IF
mode for
asynchronous
motor 1
P04.44–P00.03
25.00Hz
○
P04.51
End frequency
point for
switching off IF
mode for
asynchronous
motor 2
P04.49–P00.03
25.00Hz
○