Sln: 3-wire control/Sin, FWD: Forward running,
REV: Reverse running
Note: For dual line running mode, when
FWD/REV terminal is valid, if the inverter stops
due to stop command given by other sources, it
will not run again after the stop command
disappears even if the control terminals FWD/REV
are still valid. To make the inverter run again, you
need to trigger FWD/REV again, such as PLC
single-cycle stop, fixed-length stop, and valid
STOP/RST stop during terminal control. (See
P07.04)
These function codes define corresponding delay
of the programmable input terminals during level
variation from switch-on to switch-off.
Setting range: 0.000–50.000s
Note: After a virtual terminal is enabled, the state
of the terminal can be changed only in
communication mode. The communication
address is 0x200A.
To Next Page
Loading...
