IMO HD2-3.7A-43 - Page 60

HD2 Series Inverter Basic Operation Guidelines
-51-
Function
code
Name
Description
Default
value
when current motor is motor 1, only P02.06,
P02.07 and P02.08 will be autotuned; when
current motor is motor 2, only P12.06,
P12.07 and P12.08 will be autotuned.
4: Rotary autotuning 2, which is like rotary
autotuning 1 but is only applicable to
asynchronous motors.
5: Rotary autotuning 3 (partial autotuning),
which is only applicable to asynchronous
motors.
P00.18
Function parameter
restoration
0: No operation
1: Restore default values (excluding motor
parameters)
2: Clear fault records
3: Reserved
4: Reserved
5: Restore default values (for factory test
mode)
6: Restore default values (including motor
parameters)
Note: After the selected operation is done,
this parameter is automatically restored to 0.
Restoring the default values may delete the
user password. Exercise caution when using
this function. The option 5 can be used only
for factory testing.
0
P02.00
Type of motor 1
0: Asynchronous motor
1: Synchronous motor
0
P02.01
Rated power of
asynchronous motor 1
0.1–3000.0kW
Depends
on model
P02.02
Rated frequency of
asynchronous motor 1
0.01Hz–P00.03 (Max. output frequency)
50.00Hz
P02.03
Rated speed of
asynchronous motor 1
1–60000rpm
Depends
on model
P02.04
Rated voltage of
asynchronous motor 1
0–1200V
Depends
on model
P02.05
Rated current of
asynchronous motor 1
0.8–6000.0A
Depends
on model
P02.15
Rated power of
0.1–3000.0kW
Depends