361
5
5 High-speed Input 5.4.2 HSCS Comparison Setting
4
)
Example
2
:
●
Main program:
●
I010 interrupt subprogram
The D operand range of the DHSCS instruction can also be specied as I0x0 (x = 1–8). When the counter
reaches the set value, interrupt routines are triggered.
If M8059 is set to ON, all high-speed counter interrupts are disabled.
Differences of the ON signal on D operand with I010 or Y, M, or S outputs:
• With Y output: When the present value of C252 changes from 99 to 100 or from 101 to 100, Y is set to ON
immediately and remains ON. Even if values of C252 and K100 are not equal by comparison, Y remains ON,
unless there is an additional reset operation.
• With I010: When the present value of C252 changes from 99 to 100 or from 101 to 100, I010 will trigger only one
interrupt.
The program
is running
The program
is running
To Next Page
Loading...
