B.4 System Error Code D8063
721
Appendix
Error Code Content
D8062 Communication error in control panel or program connection port
16203 Ethernet conguration: excessive registers
16204 Ethernet conguration: failure to read or write the register
16205 Ethernet conguration: ACK signal
16206 Ethernet conguration: busy slave station
16207 Ethernet conguration: incorrect station number
16208 Ethernet conguration: memory check error
16209 Reserved
16210 Ethernet conguration: gateway path error
16211 Ethernet conguration: destination gateway path error
16212-16215 Reserved
16216 Ethernet conguration: invalid IP address
16217-16219 Reserved
16220-16239 Extension module conguration error code
16240-16259 USB communication conguration error code
16260-16279 motion control conguration error code
16260 Incorrect set value in a mechanical unit
16261 Incorrect set value of electronic gear ratio
16262 Using a cam table not congured in the background
16263 No external input master axis selected for electronic cam
16264
Electronic cam slave axis speed exceeding the maximum output speed
allowed
16265 Synchronization lower limit larger than upper limit
16266 Master axis setting out of range
16267 Incorrect number of startup latency pulses
16268 Instruction written in cam key point, invalid key point value
16269 Cam encrypted, not allowing instruction to read key points
16270 Incorrect electronic cam slave axis zoom ratio
16271 Incorrect electronic cam conguration unit
16272 Failure to modify a running electronic cam
16273 Repeated use of the electronic cam modication instruction
16274-16279 Reserved
16280-16299 Reserved
26200-26299 Reserved
B.4 System Error Code D8063
Error Code Content
D8063 Communication error
6300-6379 COM0-COMx serial communication error code
6301 Odd/even check error, overow error, and frame error
6302 Incorrect communication character
6303 Inconsistent communication data sum
6304 Incorrect data format
6305 Incorrect instruction
6306 Monitor timer timeout
6307 Reserved
6308 Reserved
6309 Reserved