Inovance H3U Series - System Error Code D8065

B.6 System Error Code D8065
723
Appendix
Error Code Content
D8064 Incorrect system parameter
6404 Incorrect parameter area setting
6405 Incorrect program area setting
6406-6424 Reserved
6425 User program check error, incorrect downloaded data
6426 Incomplete user program, including motion control subprogram
6427 PLC identier not matching user program identier
6428 Factory commissioning error
6429-6452 Reserved
6453-6465
Incorrect setting of changeable power failure retentive area of soft
elements
6466-6499 Reserved
16400-16499 Reserved
26400-26499 Reserved
B.6 System Error Code D8065
Error Code Content
D8065 User program syntax error
6501 Reserved
6502 Reserved
6503 Instruction parameter error
6504 Repeated label denition
6505 Reserved
6506 Using undened commands
6507 Incorrect Label P denition
6508 Incorrect Label I denition
6509 Reserved
6510 Reserved
6511 High-speed counter using the same input as interrupt
6512-6599 Reserved
16500-16599 Reserved
26500-26599 Reserved
B.7 System Error Code D8066
Error Code Content
D8066 User program logic circuit error
6601-6604 Reserved
6605 Incorrect instruction used in STL
6606 Incorrect instruction in incorrect position
6607 FOR-NEXT operation error
6608 MC-MCR operation error
6609-6617 Reserved
6618 Instructions allowed only in main program existing in other areas
6619 Unusable instructions existing between FOR and NEXT instructions
6620 Excessive nested layers between FOR and NEXT instructions
6621 Incorrect FOR_NEXT quantitative relationship
6622 No NEXT instruction