388
6
6 Positioning and InterpolationPLSV: Variable-speed pulse output
6) The pulse output complete interrupt is not supported in speed control mode.
7) The pulse output is stopped.
The pulse output can be stopped by setting the "pulse output stop ag bit" of special elements. See the
following table.
Y0 Y1 Y2 Y3 Y4 Attribute
M8349 M8369 M8389 M8409 M8429 Pulse output stop ag
◆
Program example
It indicates that when M1 is ON, pulses are output at a frequency of 10 kHz through the port Y1. Y4 is used
to control the running direction. If Y4 is ON, the output direction is forward.
To Next Page
Loading...
