541
7
7 Motion Control
G02: Clockwise arc interpolation; G03: Counterclockwise arc interpolation
8) During arc interpolation (CW, CCW, G02, or G03), interpolation parameters, such as the
acceleration/deceleration time, of the master axis prevail. For example, parameters of
the x-axis prevail on the XY plane; parameters of the y-axis prevail on the YZ plane; and
parameters of the z-axis prevail on the ZX plane.
Arc interpolation, and switchover of arc interpolation among XY, YZ, and XZ planes are supported.
Helix interpolation. To perform helix interpolation, set a non-zero value on an axis (the third axis) on which
the current interpolation is not performed. For example, when arc interpolation is performed on the XY
plane, set Z to 100 to perform helix interpolation.
To Next Page
Loading...
