552
7
7 Motion Control
S and T: Auxiliary parameter number
◆
Example:
It indicates M300 is set after quick positioning and then arc interpolation is performed.
S and T: Auxiliary parameter number
◆
Overview
The S and T instructions are used for setting the rotational speed of the master axis.
S0.01 – S99999.99
Major axis rotational
speed
Applicable model:
H3U-PM
Note: The master axis rotational speed is expressed by a oating-point number in r/min. The range is 0.01
to 99999.99 (two decimals). An error is returned if the value is 0.
Only program uploading/downloading is supported, but the function cannot be enabled.
◆
Overview
These instructions are used to select tools to be used.
T0 – T9999
Tool number Applicable model:
H3U-PM
Note: It indicates the tool number ranging from 0 to 9999.
Only program uploading/downloading is supported, but the function cannot be enabled.
To Next Page
Loading...
