Inovance H3U Series - Page 563

8 Electronic Cam
8.1 Establishing a Cam Table .................
564
8.1.1 Creating a Cam Table ...............
564
8.1.2 Editing a Cam Table ..................
565
8.1.3 Downloading Cam Tables .........
5
66
8.2 Selecting a Master Axis ....................
567
8.3 Setting Cyclic or Non-cyclic
Execution ...........................................
567
8.4 Starting Electronic Cams or
Electronic Gears ................................
568
8.4.1 Selecting Cam Tables or
Electronic Gears ........................
568
8.4.2 Startup ......................................
568
8.4.3 Setting Startup Latency .............
569
8.4.4 Using Comparison Interrupt ......
570
8.5 Stopping Electronic Cams or
Electronic Gears ................................
571
8.5.1 Setting Stop Mode ....................
571
8.5.2 Setting an Externally Triggered
Stop ............................................
571
8.5.3 Stop
..................................................... 572
8.5.4 Stopping Electronic Cams .........
572
8.5.5 Flag of End of Cycle and Flag
of End .........................................
573
8.6 Scaling ..............................................
574
8.7 Ejector Pin ........................................
575
8.8 Modifying Key Points for Electronic
Cams .................................................
576
8.8.1 Writing Electronic Cam Data .....
576
8.8.2 Writing Electronic Cam
Floating-point Decimal Data
........ 578
8.8.3 Reading Electronic Cam Data ...
580
8.8.4 Reading Electronic Cam
Floating-point Decimal Data
........ 581
8.9 Application Examples (Application
of H3U-PM to Strapping Band
Winding Machines) ............................
582