38
Fig. 4.29 Manual Leveling
Note:
During the installation of the printing build plate before leveling, it shall be correctly
adsorbed on the platform along the guide grooves on both sides of the platform base plate;
Clean the residual materials on the nozzle tip before leveling;
Clean the printing platform before leveling; no foreign matters shall be left;
Before leveling, clean the chamber to avoid collision with foreign matters when the
platform descends.
4.5.2.3 L&R Nozzle Z calibration
Test and calibrate the L&R Nozzle Z offset through a 0.2mm feeler gauge, and complete operation
To Next Page
Loading...
