EasyManuals Logo

Intermec EasyCoder PC4 Programmer's Reference Manual

Intermec EasyCoder PC4
170 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #163 background imageLoading...
Page #163 background image
Appendix A — Error Handling
148 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
Error Handling Principles
The firmware is able to handle a number of error conditions.
Code numbers represent the different error cases.
The printer controls output of the error code and its format and
waits until the error recovery is performed for each error code.
Error Action Source
For details on each error type, see “Error Types” on page 150.
A - Command Errors
The biggest group of error codes is command format and data
information errors such as “Syntax error” or “Form or image
name duplicate.” This source generates errors of type A.
B - Printing Errors
Printing errors, such as “Out of media,” “cover opened,” and
cutting not completed”, occur when printing cannot be
correctly performed or completed. This source generates errors of
type B, C, and D.
C - Status
A status error is not a true error case, but the operator should be
made aware of the situation. A typical case is “LTS-detection
waiting”. This source generates errors of type E.
D - Special Mode
Some errors cause the printer to stop responding or generate
unexpected output. Examples are: “Flashing not completed,” or
“Dump mode”. This source generates errors of type F and G.
Error Action Output Information
The error code may be printed in the upper left corner of the
label, “ERR01” for example. The control LED changes to orange
or red.
Serial Port (RS-232 or USB)
Output on the serial line when an error occurs is dependent
on the setup commands.
The commands UN and US turn off or on most of the error
output information.

Table of Contents

Other manuals for Intermec EasyCoder PC4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intermec EasyCoder PC4 and is the answer not in the manual?

Intermec EasyCoder PC4 Specifications

General IconGeneral
Resolution203 dpi
Power Requirements100-240 VAC, 50-60 Hz
Print MethodDirect Thermal
Max Print Width4.09 inches (104 mm)
Max Print Speed4 inches per second
Max Print Length39 inches
Media TypeRoll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width1.0 - 4.65 inches
Media Thickness0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
InterfaceRS-232
Memory4 MB Flash, 8 MB SDRAM
Operating Temperature5°C to 40°C (41°F to 104°F)
Storage Temperature-4°F to 140°F (-20°C to 60°C)
Humidity10 to 90% non-condensing

Related product manuals