Intermec EasyCoder PC4 - Or - Character Substitution

Chapter 7 — Commands
94 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
If option C is disabled, no cutting is performed after printing.
Commands JF and JB are enabled. Command f is disabled but its
value remains stored in memory.
Example:
This example shows you how to enable DT mode, disable LTS,
reverse gap sensor, and the cutter. See the command below:
ON,D 
oR - Character Substitution
Purpose: This command allows the advanced programmer to substitute
the Euro currency character (€) for any ASCII character in
printer-resident fonts 1-5. The original character can be restored
by sending the oR command.
Syntax: oR[p
1
[,p
2
]]
Combinations of Various O Command Parameters
Command LTS (N )
DT/TTR
Mode (D)
Reverse
Gap (S)
Cutter (C)
O Enable TT mode Disable Disable
OD Enable DT mode Disable Disable
OS Enable TT mode Enable Disable
OD,S Enable DT mode Enable Disable
OS,Cnnn|b Enable TT mode Enable Enable
OD,S,Cnnn|b Enable DT mode Enable Enable
ON Disable TT mode Disable Disable
ON,D Disable DT mode Disable Disable
ON,D,S Disable DT mode Enable Disable
ON,cnnn|b Disable TT mode Disable Enable
OCnnn|b Not used TT mode Disable Enable
OD,Cnnn|b Disabled DT mode Disable Enable