Intermec EasyCoder PC4 - Q - Set Label Width

Chapter 7 — Commands
ESim for the PC4 and PF8 Printer Programmer’s Reference Manual 103
Example 2:
On the tag below, the black marks are printed between the
perforations. The printer has a 203.2 dpi (8 dots/mm) printhead.
p
1
= 31 mm (248 dots)
p
2
= 7.0 mm (56 dots)
p
3
= 17 mm (136 dots)
The Q command would be:
Q248,B56-136 
q - Set Label Width
Purpose: This command is used to set the label width when using less than
full width labels.
Syntax: qp
1
.
p
3
p
2
p
1
Perforation
q Command Parameter Descriptions
Parameter Description
p
1
Width of label measured in dots.
Default:
832 at 203.dpi (8 dots/mm)
1208 at 300 dpi (11.81 dots/mm)