Intermec EasyCoder PC4 Programmer's Reference Manual

Chapter 7 — Commands
ESim for the PC4 and PF8 Printer Programmer’s Reference Manual 65
EI - List Soft Fonts
Purpose: This command makes the printer print a list of all soft fonts that
are stored in memory.
Syntax: FE
Remarks: This command is related to ES (Store Soft Fonts) and EK (Delete
Soft Fonts).
Recommended Density Settings For Thermal Transfer Printing
Label/Tag Type Ribbon Type
Recommended
Density at Speed S =
2
Maximum
Speed
Duratran II Standard D4 S3
Duratran II Tag Standard D4 S2
Duratran II Premium D5 S3
Duratran II Tag Premium D6 S2
Kimdura Premium D6 S3
Matte Polyester Premium D6 S3
Gloss Polyester Super premium D7 S3
TTR Uncoated GP02 D1 S2
TTR Matte Coated HP05 D6 S3
TTR Premium HP05 D4 S3
TTR Premium Board HP05 D7 S1
TTR Polyethylene HP05 D2 S3
TTR Gloss Polyethylene HP05 D7 S3
TTR High Gloss White Premium HP05 D7 S3
TTR Matte Coated HP07 D7 S3
TTR Premium Board HP07 D8 S1
TTR Polyethylene HP07 D4 S3
TTR Gloss Polyethylene HP97 D8 S3
TTR High Gloss White Premium HP07 D9 S3
TTR High Gloss Polyester HR03 D7 S3

Intermec EasyCoder PC4 Specifications

General

Resolution	203 dpi
Power Requirements	100-240 VAC, 50-60 Hz
Print Method	Direct Thermal
Max Print Width	4.09 inches (104 mm)
Max Print Speed	4 inches per second
Max Print Length	39 inches
Media Type	Roll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width	1.0 - 4.65 inches
Media Thickness	0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
Interface	RS-232
Memory	4 MB Flash, 8 MB SDRAM
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	10 to 90% non-condensing