Chapter 7 — Commands
86 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
j - Media Feed Adjustment
Purpose: This command makes it possible to set the media feed for tear-off
(straight-through), peel-off (self-strip), or cut-off operation.
Syntax: jp
1
.
Remarks: When using peel-off operation, the labels should remain slightly
stuck to the liner (backing paper) so they do not fall off but can
still can be easily removed.
In tear-off operation, the j command adjusts the media feed so
that the perforation between tags or gap between labels is aligned
with the tear bar.
The extra media feed set by the j command can be enabled or
disabled using JF and JB “Top of Form Backup” commands. By
default, “Top of Form Backup” is enabled.
j Command Parameter Descriptions
Parameter Description
p
1
Length of media feed after printing in dots
(0-160).
Recommended values at 203.2 dpi (8 dots/mm):
• Tear-off (straight-through) operation: 136
(default)
• Peel-off (self-strip) operation: 110
Recommended values at 300 dpi
(11.81 dots/mm):
• Tear-off (straight-through) operation: 204
(default)
• Peel-off (self-strip) operation: 165
Do not use extremely small or large values for the j command
as such values may cause the printer to feed or pull back the
media continuously.
To Next Page
Loading...
