Chapter 7 — Commands
92 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
.
Example:
MO
UM
UM150000,2048,0,0,0,0,0,0,UI80,001
Now, insert a 256 MB CF card into the printer and type:
UM150,249912,0,0,0,0,0,0,0,UI80,001
N - Clear Image Buffer
Purpose: This command is used to clear the image buffer before building a
new image. It also clears any error list that has not been
presented.
Syntax: N
Remarks: The N command is essential when printing labels in Direct
mode. It is not necessary to use the N command before printing a
form. The N command must not be used inside a form in the
Form Edit mode.
O - Option Select
Purpose: This command is used to enable or disable various sensors and
the cutter.
Syntax: O[Sp,N[,D[,Cnnn|Cb]]]
.
Memory Command Parameter Descriptions
Parameter Description
p
1
Memory select value:
0 = Select printer memory (default).
1 = Select the CF card memory.
F = Format the CF card.
O Command Parameter Descriptions
Parameter Description
S Enable reverse gap sensing.
N Disable label taken sensor.
To Next Page
Loading...
