Intermec EasyCoder PC4 - FS - Form Store

Chapter 7 — Commands
74 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
Syntax: FR“name”
.
Remarks: To print a list of forms currently stored in memory, use the FI
command.
Example:
To retrieve the form named “Test1,” enter the command below:
FR“Test1” 
FS - Form Store
Purpose: This command is used to begin a Form Store sequence.
Syntax: FS“name”
Remarks: All commands following FS are stored in the Forms memory
until a FE command is received to end the form store process. If a
form with the same name is already stored in memory, the FS
command results in an error and the old form is retained. When
updating a form, use the FK command to delete the old version
before storing the new version. To print a list of the forms
currently stored in memory, use the FI command.
Global commands, such as EI, EK, ES, FI, FK, GI, GK, GM, I,
N, P, U, UE, UF, UG, UI, UM,UP, UN, US, Y, W, ?, or ^@
should not be used in a form store sequence.
FR Command Parameter Descriptions
Parameter Description
“name” This is the form name used when the form was
stored. The printer is case sensitive.
FS Command Parameter Descriptions
Parameter Description
“name” This is the form name used when retrieving the
stored form. The name may be from 1-8
characters. The printer is case sensitive (the form
names are stored with the exact case entered on
the FS command line).