Intermec EasyCoder PC4 - SA - Setup Adjust

Chapter 7 — Commands
108 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
SA - Setup Adjust
Purpose: This command is used to control the activation and storage of
setup commands and values.
Syntax: SAp
1
.
Remarks: The SA command affects the following setup commands: R, r, D,
j, J, q, Q, S, Z, and SPC. The current SA value is stored in Flash
memory and printed on the test label.
Example:
This example shows how to ignore all setup commands within a
form.
SA2 
SA Command Parameter Descriptions
Parameter Description
p
1
Setup adjust value:
0 = All commands remain active and values are
saved when changed. The printer uses stored
setup values (default).
1 = All setup parameters are locked and
commands are ignored. The printer uses only
previously stored setup values.
2 = All setup commands within forms are ignored.