Chapter 2 — Command List
12 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
Commands
The tables below lists all commands available for the ESim
protocol for the PC4 and PF8 printers.
General Setup Commands
Command Description Note
I Character set selection
i Asian character spacing
oR Character substitution
UC Command reply accept character control
W Windows mode PC4 only
Y Serial port setup
Print Setup Commands
Command Description
DDensity
f Cut position
JB Disable top of form backup
JF Enable top of form backup
j Media feed adjustment
O Option select
QSet form length
q Set label width
R Set reference point
r Set relative reference point
S Speed select
SA Setup adjust
SPC Setup print copy
Z Print direction
To Next Page
Loading...
