Intermec EasyCoder PC4 Programmer's Reference Manual

Chapter 7 — Commands
114 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
Example:
The example below shows a UDC command and a sample
response.
UDC 
004 
1-972698-02,Cardfirm 02 
1-972601-01,Base 4.01 
1-972699-01,Bootfirm 01 
1-972697-33,Intfont 01 
UE - Soft Font Information Inquiry
Purpose: This command makes the printer send information back to the
host on the soft fonts stored in memory.
Syntax: UE
Remarks: The printer sends the number of soft fonts and the name, height,
and direction of each soft font through the RS0232 or USB port.
The UE command is executed directly without appending a
Linefeed.
Example:
UE 
UF - Form Information Inquiry
Purpose: This command causes the printer to send information about
forms currently stored in the printer back to the host.
Syntax: UF
Remarks: The printer sends the number of forms stored and the name of
each form to the host through the RS-232 or USB port.
The UF command is executed directly without appending a
Linefeed.
UG - Graphics Information Inquiry
Purpose: This command causes the printer to send information about
graphics currently stored in the printer back to the host.
Syntax: UG
Remarks: The printer sends the number of forms stored and the name of
each form to the host through the RS-232 or USB port.

Intermec EasyCoder PC4 Specifications

General

Resolution	203 dpi
Power Requirements	100-240 VAC, 50-60 Hz
Print Method	Direct Thermal
Max Print Width	4.09 inches (104 mm)
Max Print Speed	4 inches per second
Max Print Length	39 inches
Media Type	Roll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width	1.0 - 4.65 inches
Media Thickness	0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
Interface	RS-232
Memory	4 MB Flash, 8 MB SDRAM
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	10 to 90% non-condensing