Intermec EasyCoder PC4 Programmer's Reference Manual

Chapter 7 — Commands
96 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
Example:
This example prints two label sets of one label each, see the
command below:
P2,1 
The principles for how counters are printed by this example,
where the print command is
P2,2.
PA - Print Automatic
Purpose: This command is used in a stored form sequence to automatically
print the form as soon as all variable data has been supplied.
Syntax: PAp
1
[,p
2
]
.
Counter: 1
Label No. 1
Counter: 1
Label No. 2
Counter: 2
Label No. 3
Counter: 2
Label No. 4
PA Command Parameter Descriptions
Parameter Description
p
1
Number of label sets (1-65535).
p
2
Number of copies of each label (1-64435) that is
used in combination with counters to print
multiple copies of the same label.

Intermec EasyCoder PC4 Specifications

General

Resolution	203 dpi
Power Requirements	100-240 VAC, 50-60 Hz
Print Method	Direct Thermal
Max Print Width	4.09 inches (104 mm)
Max Print Speed	4 inches per second
Max Print Length	39 inches
Media Type	Roll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width	1.0 - 4.65 inches
Media Thickness	0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
Interface	RS-232
Memory	4 MB Flash, 8 MB SDRAM
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	10 to 90% non-condensing