Intermec EasyCoder PC4 Programmer's Reference Manual

Chapter 1 — Introducing ESim
8 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
Most computer-based systems send CR/LF when pressing the
Enter key. The CR (carriage return) sent in a CR/LF sequence is
ignored. Sending a CR alone has no effect.
Refer to Chapter 2, “Command List” on page 11 for
information on when the various commands can be used.
Field
Each command line of printable data creates a field with certain
values for start position, rotation, magnification, and so forth.
The illustration shows how a label is printed and fed out using the default
direction.
ESim commands and parameters must be used only as
described in this manual. Use of unknown commands and
parameters may cause permanent printer malfunction.
PRODUCT NAME
FRAGILE
PACKED BY: SAM
SERIAL NO. 654
76532
Box
Counter C1
Rotated text
Rotated text
Line
Fixed text
Counter C0
Variable
text V00
Graphic
Y axis
X axis
Feed
direction

Intermec EasyCoder PC4 Specifications

General

Resolution	203 dpi
Power Requirements	100-240 VAC, 50-60 Hz
Print Method	Direct Thermal
Max Print Width	4.09 inches (104 mm)
Max Print Speed	4 inches per second
Max Print Length	39 inches
Media Type	Roll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width	1.0 - 4.65 inches
Media Thickness	0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
Interface	RS-232
Memory	4 MB Flash, 8 MB SDRAM
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	10 to 90% non-condensing