Chapter 7 — Commands
ESim for the PC4 and PF8 Printer Programmer’s Reference Manual 71
Remarks: Exception of output: Error 07 “Out of media or ribbon,” is added
after 07 with Pnnn or Rnnn, where nnn = number of remaining
labels:
Output at error media action (mode 0):
<NAK>07Pnnn<XOFF>
Output at error ribbon action (mode 0):
<NAK>07Rnnn<XOFF>
Output at error recovery:
<XON>
Mode 1, 2, and 6 changes the output in a similar way.
All parameters are saved in flash memory. If more than one error
occurs at the same time, there is an output for each error
recovery, like
<p
1
>00<CRLF> on mode 2. For more information
on error handling, “Error Handling Principles” on page 148 in
Appendix A.
Example:
f - Cut Position
Purpose: This command is used to adjust the cutting position along the y-
axis in relation to the media according to other characteristics of
individual printers and batches of media.
Syntax: fp
1
Command
Manual
Action
Reply Comments
US
<ACK> Enables error reporting.
eRC,2,Q Reply error with character
“C” and error NN and at
recovery with character
“Q”.
Open cover C11<CRLF> Manual action generates
error 11.
Close cover Q00<CRLF> Manual recovery on error
11.
To Next Page
Loading...
