Chapter 7 — Commands
ESim for the PC4 and PF8 Printer Programmer’s Reference Manual 113
Parameter p
1
saves in Flash.
If command UC is activated, it replaces the <ACK> character at
the end of command US and P.
If an error occurs and error report is activated, the error message
is sent instead.
Example:
The table below shows an example of the UC command with the
a reply.
UDC - Memory Cartridge Information (PC4 only)
Purpose: This command checks an inserted memory cartridge and returns
information on its content on the RS-232 or USB channel.
Syntax: UDC
Remarks: This command checks the memory cartridge for the following
information and returns one of the following alternatives listed in
the table below.
Command Reply Explanation
UC062
> Set Command Reply Accept
character to “>”.
US
> Reply error.
X50,200,5,400,20
>Draw a box.
P
> Print box and reply “>” at ready.
Memory Cartridge Commands and Explanations
Command Explanation
NA
Cartridge not detected.
000
Cartridge detected, but no relevant
information is found.
001-004
Cartridge detected. Followed by one to four
lines of information on detected firmware,
and/or Asian fonts.
To Next Page
Loading...
