Intermec EasyCoder PC4 - C - Counter

Chapter 7 — Commands
58 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
Example
N 
b40,40,Q,sM,x1,“ABCDEFGHIJKLMNOPQRSTUVWHYZ123456789
012345678901234ABCDEFGHIJKLMNOPQ
RSTUVWHYZ1234”

P1 
C - Counter
Purpose: This command is used to define one of maximum 10 automatic
counters used in consecutive numbering applications, such as
serial numbers. Counters can only be used in the Form Edit
mode, and not in the Direct mode.
Syntax: Cp
1
,p
2
,p
3
,p
4
,[p
5
,],“PROMPT”
.
C- Counter Parameter Descriptions
Parameter Description
p
1
Counter number (0-9).
p
2
Maximum number of digits for the counter
(0-29).
p
3
Field justification:
L = Left justification.
R = Right justification.
C = Center justification.
N = No justification.
p
4
Step value. Plus or minus sign followed by a single
digit (1-9):
+ Increase.
- Decrease.