Activating and Assigning Flight Modes
S-12
In the factory default setting, all flight modes are inhibited.
Flight modes are activated and assigned to the desired
switch position using the SPEED and LAUN functions in
the Device SEL screen.
In system mode list rotate the Selector until Device SEL
is highlighted. Press the Selector to access the Device
Select screen.
To activate the launch, cruise, and land mode, rotate the
Selector until
LAUN is highlighted and then press the
Selector. The following screen will appear:
At this point, you must decide which 2- or 3-position
switch you prefer to assign the flight mode to. If a
2-position switch is selected, launch and cruise will be
active. If a 3-position switch is selected, the launch, cruise
and land will be activated. We recommend starting with
the L3P (left 3 position) switch, as this is a convenient
place. Rotate the Selector until the desired switch is
highlighted and press to select.
AIL D/R = Aileron dual rate switch
ELE D/R = Elevator dual rate switch
RUD D/R = Rudder dual rate switch
AUX4 = Auxiliary 4 switch
R3P = Right 3-position switch
L3P = Left 3-position switch
BTFL = Butterfly switch
To Next Page
Loading...
Need help?
General
