Step #33 Elevator-to-Flap Mix
Step #34 Aileron-to-Flap
Step #35 Aileron Differential
S-64
This function is normally not used in land mode. It was
addressed above in setting up the cruise mode.
This function is normally not used in land mode.
It was addressed above in setting up the launch
and cruise modes.
In
FUNC.LIST rotate the Selector until DIFFEREN. is
highlighted. Press the Selector to access the Aileron
differential menu. Rotate the Selector to highlight the
land aileron value then press the Selector to access that
value. With the flight mode switch in the lower land mode,
give a full right aileron command and rotate the Selector
to achieve the desired aileron differential for land.
Note: Reverse differential is common for
landing mode to give greater roll control when
the flaps are deployed.
Pressing the Selector will store the value. Now rotate the
Selector to highlight the land flap value and adjust it to
the desired position. Press the LIST button to return to
the Function Mode screen.
To Next Page
Loading...
Need help?
General
