UTILITY FUNCTIONS
COPY – COPY THE CURRENTLY SELECTED MODEL TO ANOTHER MODEL MEMORY
A-49
The Copy function is part of the Model SEL function
described earlier and allows the contents of the current
model memory to be copied into another model memory
in the same transmitter. It is not used to transfer the
model to another transmitter or to a DataSafe
™
unit – the
TRANSFER function provides for these activities.
The Copy function is very valuable because it can provide
some insurance against losing programs (aircraft setups)
that may have been time-consuming to create. It is
strongly recommended that the Copy function be used to
make a backup copy of the model memory for safekeeping
after programming for a model has been completed, tested
and refined.
Making a backup copy of the model memory protects
against losing the original program and also allows one
to experiment with the original program, knowing that the
original settings can be restored by copying the backup
copy back to the original model memory.
1. The model to be copied must be currently selected –
see Model SEL description at the beginning of the
ACRO section.
The X9303 2.4 System includes two utility functions
to help with managing the settings that have been
programmed into the X9303 2.4 model memories. These
functions include Copy and TRANSFER, both of which
are located in the SYSTEM Menu. The Copy function
is actually part of the Model SEL function while the
TRANSFER function has its own set of displays.
To Next Page
Loading...
Need help?
General
