Aileron-to-Flap Mix
Differential
S-22
Aileron-to-flap mix causes the flaps to move in unison
with the ailerons. This function gives added roll response
by mixing ailerons to flaps such that the entire trailing
edge functions as an aileron.
To access aileron-to-flap mix, in FUNC.LIST rotate the
Selector until
AILFLP M is highlighted. Press the
Selector to access the Aileron-to-Flap mix.
Note: Two aileron-to-flap mix values are
available—Pos0 and Pos1. Switches are available
at the bottom of the screen that allow the selection
of Pos0 or Pos1.
Note that position 1 always has priority over position
0. Press the LIST button to return to the Function
Mode screen.
Differential (typically more up aileron travel than down) is
utilized to reduce adverse yaw and to improve the turning/
handling characteristics. Aileron and flap differentials can
be adjusted for each of the 5 flight modes.
To access Differential, in
FUNC.LIST rotate the Selector
until
DIFFEREN. is highlighted. Press the Selector to
access the Aileron differential menu. Rotate the Selector
to highlight the desired flight mode and aileron or flap
value, and then press the Selector to access that value.
With the flight mode switch in the corresponding mode,
give a full right aileron command and rotate the Selector
to achieve the desired aileron or flap differential. Pressing
the Selector will store the value. Press the LIST button
to return to the Function Mode screen.
To Next Page
Loading...
Need help?
General
