Step #18 Aileron-to-Flap
Step #19 Aileron Differential
S-52
This function gives added roll response by mixing
ailerons to flaps such that the entire trailing edge
functions as an aileron. In
FUNC.LIST rotate the Selector
until
AILFLP M is highlighted. Press the Selector to
access the Aileron-to-flap mix. Rotate the Selector to
highlight
LND then press the Selector selecting Pos1.
Rotate the Selector to highlight Pos1 above and press
the Selector to access the aileron-to-flap values. With
the flight mode switch in the upper launch position, move
the aileron control stick full right and hold while adjusting
the aileron-to-flap value by rotating the Selector until the
desired mix is achieved. Press the
LIST button to return
to the Function Mode screen.
In
FUNC.LIST rotate the Selector until DIFFEREN. is
highlighted. Press the Selector to access the Aileron
differential menu. Rotate the Selector to highlight the
launch aileron value then press the Selector to access
that value. With the flight mode switch in the upper launch
mode, give a full right aileron command and rotate the
Selector to achieve the desired aileron differential for
launch. Pressing the Selector will store the value. Now
rotate the Selector to highlight the launch flap value and
adjust it to the desired position. Press the LIST button to
return to the Function Mode screen.
To Next Page
Loading...
Need help?
General
