X9303 2.4 Transmitter Features (Internal)
Control Stick Tension Adjustment
G-15
Remove the six transmitter screws from the back cover as
shown on page G-14. Remove the transmitter back, being
careful not to cause damage to any components.
Adjust each gimbal tension screw for desired tension
(counter-clockwise to loosen stick tension; clockwise to
tighten stick tension). When adjusting the throttle ratchet
tension, make sure that the adjusting screw does not
touch the PC board after adjustment is complete.
Back of Transmitter (Mode 2)
THROTTLE TENSION SCREW
RUDDER TENSION SCREW
ELEVATOR TENSION SCREW
AILERON TENSION SCREW
To Next Page
Loading...
