TRANSFER – TRANSFER THE MODEL TO ANOTHER TRANSMITTER OR TO DataSafe
RECEIVE A MODEL INTO THE X9303 2.4 – (Transfer function)
A-51
1. Hold the ENT button while plugging the trainer cord
into the back of the transmitter to obtain the
SYSTEM Menu.
Plug the other end of the trainer cord into another
X9303 2.4 or XP9303 transmitter while holding the ENT
button down and prepare that transmitter for Receive as
described below. Or, plug the other end of the trainer cord
into a DataSafe unit and prepare the DataSafe for Receive.
2. Highlight and select TRANSFER in the SYSTEM
Menu to obtain the Transfer display.
The TRANSFER function can be found in the SYSTEM
Menu and is used to copy the contents of a model
memory to another X9303 2.4, XP9303 transmitter or
to a DataSafe device on a Personal Computer (PC). It is
also used to receive data for a model, either from another
X9303 2.4, XP9303 transmitter or from a DataSafe unit.
3. The model to be transferred must be the currently
selected model. If the model to be transferred is not
currently selected, see Model SEL in the SYSTEM
Menu to select the model to be transferred to another
X9303 2.4, XP9303 or DataSafe unit.
4. When the receiving device is ready, press the CLR
button next to START on the left side of the display.
The data for the currently selected model is transferred
to the receiving device.
To Next Page
Loading...
Need help?
General
