Step #31 Land Pre-sets
S-62
The X9303 2.4 offers a sophisticated program that allows
easy preset trim positions for the elevator, flaps, flaperons
(and even the aileron and rudder if you choose). The
system can remain active in flight allowing you to fine
trim presets in each flight mode or can be locked in so
they cannot be altered in flight. Flight mode presets are
automatically selected via the flight mode switch and are
adjusted with the digital elevator trim, the digital flap trim
and the digital auxiliary trim (flaperon). While the presets
are adjusted via the digital trims, their positions are
recorded in the servo monitor.
To access the servo monitor, in FUNC.LIST rotate the
Selector until
MONITOR is highlighted. Press the
Selector to access the Monitor menu then press the
Selector again to access the camber digital preset
screen. To adjust the presets, move the flight mode switch
to the land mode (down) position. Adjust the preset
positions via the flap trim, auxiliary trim and elevator trim
on the transmitter. The values will be displayed in the
screen and then will be memorized for that flight mode. If
you wish to have these preset values be fixed (not active
in flight) once the values are established, return to the
Trim Step screen in the system mode and reduce the value
of the desired channel to 0. The preset values for all flight
modes will be stored and no longer accessible with the
digital trims.
To Next Page
Loading...
