Flap Rate
Motor Hold
S-27
Flap Rate allows the independent up and down adjustment
of flaps with the lever that camber mix is assigned to (flap
lever or Aux. 3 lever) in Device Select (pg. S9) for each of
the flight modes. The lever-offset position is established
in camber mix above, allowing pilots to choose the neutral
position for the side lever and this offset is in effect in
the flap rate menu (see Camber Mix for more details). It’s
important to first program these values before proceeding
to the camber mix menu, as the camber mix values are
based on a percentage of the flap values.
To access Flap Rate in FUNC.LIST rotate the Selector
until
FLAP RATE is highlighted. Press the Selector
to access the Flap Rate menu. Rotate the Selector to
highlight the desired value then press the Selector to
access this value. With the flight mode switch in the
corresponding launch mode, move the left side lever
to the appropriate position and adjust the value to the
desired flap position. Repeat this for all desired flight
modes and flap positions. Press the LIST button to return
to the Function Mode screen.
Note: This function is only available when the motor
is programmed to the spoiler stick in the device
select menu. See Device Select Pg. S-11.
The Motor Hold feature allows the spoiler stick to be used
for multiple functions. In one mode (launch mode, for
example) it can be used as a proportional throttle for an
electric motor and switching to another mode (landing)
the spoiler can be used as landing flaps. The motor hold
function is used in conjunction with a programmable mix
by mixing motor to an AUX channel. When the motor hold
mix is on, the throttle hold program holds the throttle in
the desired position (usually motor off).
To access Motor Hold in
FUNC.LIST rotate the Selector
until
MOTO. HOLD is highlighted. Press the Selector
to access the Motor Hold menu. Rotate the Selector to
highlight desired flight mode or switch, and then press
the Selector to access on or off. Adjust the motor value
to achieve the desired throttle position for that flight mode
or switch. Press the LIST button to return to the Function
Mode screen.
To Next Page
Loading...
