MULTI-POINT PROGRAMMABLE MIXER (continued)
S-34
Slave Channel - (Multi-Point Mixer)
This is the Slave channel that will move according to the
program mix in relation to the Master channel.
The Slave channel is selected by highlighting and
selecting this parameter to obtain a list of channels and
then selecting the Slave channel from the list. The list
contains each of the 9 channels in the system.
Point Names/Numbers - (Multi-Point Mixer)
The points that can be adjusted are listed vertically by
name and are also displayed by number along the bottom
of the graph.
Change the value of a point by highlighting and selecting
the point name and dialing-in the desired percentage.
Current Point Setting - (Multi-Point Mixer)
This list shows the setting for each of the 7 adjustable
points (Point-0, 1, 2, 3, 4, 5, 6). The value of each point
determines where the point is positioned vertically on the
graph, which dictates the Slave servo position. The point
values can be set from -100 to +100 with -100 being full
deflection in one direction and +100 being full deflection
in the other direction. A value of 0 indicates the Slave’s
center or neutral position. The overall travel of the slave
channel is determined by the Travel settings described
earlier in the TRVL ADJ. function.
A point value of
INH can also be set for points 1, 2, 4, and
5. When set to INH the point takes on a value represented
by the intersection of the cursor and the Curve/Line
between the 2 adjacent points. For instance, if Point-1 is
set to -67, Point-2 is set to INH and Point-3 is set to 0,
then Point-2, which is inhibited, takes on a value of -34,
which is midway between points 1 and 3.
The value for a point can be changed by highlighting and
selecting the Point Name to the left of the point value and
then dialing-in the desired value.
Pressing the CLR button when a point value is
highlighted resets the point to original settings. The
original settings are:
Point-0 -100
Point-1 INH
Point-2 INH
Point-3 0
Point-4 INH
Point-5 INH
Point-6 +100
Cursor - (Multi-Point Mixer)
The cursor shows the current Master channel position.
When the Master channel is deflected fully in one
direction, the cursor is to the extreme left over Point-0,
when it is at neutral it is in the center over Point-3 and
when it is fully deflected in the other direction the cursor
is at the extreme right of the graph over Point-6.
The cursor moves across the 7 points as the Master is
moved from one extreme to the other. Where the cursor
intersects the Curve/Line over a given point defines the
amount of Slave servo deflection, which is equal to the
value assigned to the point. For example, if Point-2 is set
to 30% then the servo will deflect 30% from neutral when
the Master is advanced so the cursor is over that point.
To Next Page
Loading...
Need help?
General
