Juniper MX10004 - MX10004 Cable Specifications for Console and Management Connections

third-party opcal module or cable and, if required, replace it with an equivalent
Juniper-qualied component.
Use of third-party opcal modules with high-power consumpon (for example,
coherent ZR or ZR+) can potenally cause thermal damage to or reduce the lifespan of
the host equipment. Any damage to the host equipment due to the use of third-party
opcal modules or cables is the users’ responsibility. Juniper Networks will accept no
liability for any damage caused due to such use.
MX10004 Cable Specicaons for Console and Management
Connecons
Table 37 on page 96 lists the specicaons for the cables that connect the MX10004 router to a
management device.
NOTE: You can congure the MX10004 with small form-factor pluggable (SFP) management
ports that support 1000BASE-SX transceivers.
Table 37: Cable
Specicaons for Console and Management Connecons for the MX10004 Routers
Port on MX10004
Router
Cable Specicaon Cable Supplied Maximum
Length
Device
Receptacle
Console port RS-232 (EIA-232) serial
cable
One 7-foot (2.13-meter)
long RJ-45 patch cable
and RJ-45 to DB-9
adapter
2.13 meters RJ-45
Management port Category 5 cable or
equivalent suitable for
1000BASE-T operaon
One 7-foot (2.13-meter)
long RJ-45 patch cable
100 meters RJ-45
96