Juniper MX10004 - Unpack the MX10004 Router; Unpack the MX10004 Shipping Pallet

Unpack the MX10004 Router
SUMMARY
Unpack the router using the recommended tools and
following the recommended procedure.
IN THIS SECTION
Unpack the MX10004 Shipping Pallet | 108
Unpack Line Cards, Roung Control Boards,
and Switch Fabric Boards for the MX10004
Router | 111
Compare the MX10004 Router Order to the
Packing List | 112
Register Products—Mandatory to Validate
SLAs | 119
Unpack the MX10004 Shipping Pallet
Gather the following tools and parts to unpack the Juniper Networks MX10004 router:
• Phillips (+) screwdriver, number 2
• 1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the shipping pallet
• A box cuer or packing knife to slice open the nylon straps and tape that seal the crate and boxes
• Blank panels to cover any slots not occupied by a component
Aer you prepare the installaon site as described in Table 28 on page 80, you can unpack the router.
The MX10004 router chassis is a rigid sheet-metal structure that houses the hardware components. The
chassis ships in a cardboard box that has a two-layer wooden pallet base with foam cushioning between
the layers. The router chassis is bolted to the pallet base. The carton also contains an accessory box and
a rack-mount kit.
NOTE: The chassis is well protected inside the shipping box. Keep it secure in its packaging unl
you are ready to begin installaon.
108