Juniper MX10004 - MX10004 Line Card Maintenance

5. Grasp the handles, and slide the RCB about halfway out of the chassis (see Figure 87 on page 191).
Figure 87: Removing a Roung and Control Board
6. Grasp each side of the RCB and slide it completely out of the chassis.
7. Place the RCB on the anstac mat.
8. If you are not replacing the RCB now, install a cover panel in the empty slot.
MX10004 Line Card Maintenance
SUMMARY
Maintaining Juniper Networks MX10004 routers
includes removing and reinstalling line cards.
IN THIS SECTION
Handle and Store MX10004 Line Cards
Properly | 192
Handle an MX10004 Line Card
Properly | 192
Store a Line Card Properly | 193
Bring an MX10004 Line Card Online or Take
It Oine | 194
191