Juniper MX10004 - Install the Front Door on an MX10004 Router

12. Aach the restraint to the rack by inserng six mounng screws through each open ange hole and
rack hole (see Figure 43 on page 127). Tighten the screws.
Figure 43: Aach the Safety Restraint
Install the Front Door on an MX10004 Router
SUMMARY
The front door (JNP10004-FRNT-PNL) on the
Juniper Networks MX10004 router protects the
ber-opc cabling and protects the router from
electromagnec interference (EMI).
IN THIS SECTION
Install a Front Door Without the Air Filter on
an MX10004 Router | 128
Install a Front Door with Filter | 130
You can install the front door with or without the oponal cable management system. You can also order
JNP10004-FPNL1 for installaons that require an air lter.
127