Juniper MX10004 - JNP10 K-PWR-DC2 Power Supply

JNP10K-PWR-DC2 Power Supply
The JNP10K-PWR-DC2 power supply provides two power supplies in a single housing that accepts
either 60 A or 80 A using four redundant input power feeds. The two internal power supplies (PS_0 and
PS_1) each have redundant input feeds: A0 and/or B0 for PS_0 and A1 and/or B1 for PS_1. You
congure the input using a set of three DIP switches on the power supply faceplate that sets the
combined output power for both internal power supplies. The output depends on the sengs of these
DIP switches. See Table 18 on page 50 and Figure 24 on page 51.
Table 18: DIP Switch Sengs for JNP10K-PWR-DC2 Power Supplies
INP0
(Switch 1)
INP1
(Switch 2)
H/L
(High Input 80 A/
Low Input 60 A)
Output Power
On On On (80 A) 5500 W
On On O (60 A) 4400 W
On O On (80 A) 2750 W
O On On (80 A) 2750 W
On O O (60 A) 2200 W
50