Juniper MX10004 - MX10004 Routing and Control Board Leds

• When pressed for fewer than 5 seconds for diagnosc purposes, the RCB does not reset. The
press event is logged in the RCB FPGA register.
• When pressed for more than 5 seconds but fewer than 10 seconds, the RCB reboots and the
reset-reason logs the buon press event.
• When pressed for more than 10 seconds, the RCB reboots with an opon for BIOS recovery.
• LEDs—Provide status of the Roung Engine.
• Online/Oine Buon—When the RCB is online, and if the buon is pressed for more than 4
seconds, the RCB goes oine. When the RCB is oine, and if the buon is pressed more than 4
seconds, the RCB starts boong.
NOTE: For specic informaon about Roung Engine components (for example, the amount of
DRAM), issue the show vmhost hardware command.
MX10004 Roung and Control Board LEDs
IN THIS SECTION
Roung and Control Board Status Panel LEDs | 60
SATA SSD LEDs | 61
Clock LEDs | 61
MX10004 Management Port LEDs | 62
59