Juniper MX10004 - Pack MX10004 Components for Shipping

16. Aach the cardboard box to the wooden pallet by screwing two screws into each of the four pallet
fasteners. See Figure 114 on page 235.
Figure 114: Aach the MX10004 Router to the Pallet
17. Write the RMA number on the exterior of the box to ensure proper tracking.
Pack MX10004 Components for Shipping
Before you begin to pack a router component, ensure that you have the following parts and tools
available:
• Anstac bag for each component
• Electrostac discharge (ESD) grounding strap
CAUTION: Do not stack router components. Return individual components in separate
boxes if they do not t together on one level in the shipping box.
To pack MX10004 components for shipping:
1. Place individual FRUs in anstac bags.
2. Use the original packing materials if they are available. If the original packing materials are not
available, ensure that the component is adequately packed to prevent damage during transit. The
packing material you use must be able to support the weight of the component.
3. Ensure that the components are adequately protected with packing materials and packed so that the
pieces cannot move around inside the carton.
4. Close the top of the cardboard shipping box and seal it with packing tape.
235