Juniper MX10004 - Install an MX10004 Routing and Control Board

NOTE: Because these units are heavy and anstac bags are fragile, two people should insert
the RCB into the bag.
To store an RCB in an electrostac bag:
1. Hold the unit horizontally with the faceplate toward you.
2. Have the second person slide the opening of the anstac bag over the connector edge and then
pull the bag to cover the unit.
If you must insert an RCB into a bag by yourself:
1. Lay the unit horizontally on an anstac mat that is on a at, stable surface with the sheet-metal side
down.
2. Orient the unit with the faceplate toward you.
3. Carefully insert the connector edge into the opening of the bag and pull the bag toward you to cover
the unit.
Install an MX10004 Roung and Control Board
A Juniper Networks MX10004 router can have one or two Roung and Control Boards (RCBs),
depending on the conguraon. You can install RCBs in either of the two top slots on the front of the
chassis.
In redundant conguraons, an RCB is a hot-removable and hot-insertable eld-replaceable unit (FRU).
In base conguraons, you need to install a second RCB before removing a failing RCB in order to
prevent the router from shung down.
Before you install an RCB, ensure that you have an electrostac discharge (ESD) grounding strap.
To install an MX10004 RCB:
187