Juniper MX10004 - Install a JNP10 K-PWR-AC2 Power Supply

Install a JNP10K-PWR-AC2 Power Supply
CAUTION: Use the same type of power supply in all slots. Do not mix AC and DC
power supplies in a producon chassis.
WARNING: Protect yourself from severe burns by wearing heat-protecve gloves when
removing a running JNP10K-PWR-AC2 power supply from the chassis. The power
supply can reach temperatures from 158° F to 176° F (70° C to 80° C) under running
condions.
Before you install a JNP10K-PWR-AC2 power supply in the chassis:
• Ensure that you have followed all safety warnings and cauons.
• Review how to prevent ESD damage. See "Prevenon of Electrostac Discharge Damage" on page
263.
• If the AC or DC power source outlets have a power switch, set them to the o (O) posion.
• Have a qualied electrician install the HVAC and HVDC connectors and lugs.
• Ensure that you have the following parts and tools available to install the JNP10K-PWR-AC2 power
supply:
• Electrostac discharge (ESD) grounding strap
• Phillips (+) screwdriver, number 1
• Power cables appropriate for your geographical locaon (for low-voltage installaons) or input
amperage (for high-voltage installaons). See "MX10004 Power Cable Specicaons" on page 44.
To install a JNP10K-PWR-AC2 power supply in an MX10004:
148