Juniper MX10004 - MX10004 Transceiver and Fiber Optic Cable Installation and Removal

8. Drape and e the opcal cables to the side (see Figure 100 on page 205). Another opon is to drape
some of the cables under the handle extension and some cables over the handle extension.
Figure 100: Completed Cable Management System
MX10004 Transceiver and Fiber
Opc Cable
Installaon and Removal
IN THIS SECTION
Install a Transceiver in an MX10004 Line Card | 206
Remove a Transceiver from an MX10004 Line Card | 207
Connect a Fiber-Opc Cable to an Opcal Transceiver in an MX10004 Router | 209
Disconnect a Fiber-Opc Cable from an Opcal Transceiver on an MX10004 Router | 210
Fiber-Opc Cable Maintenance for an MX10004 Router | 211
205