Juniper MX10004 - USB Port Specifications for the MX10004 Router

Table 39: Console Port Connector Pinouts for the MX10004 Router
Pin Signal Descripon
1 RTS Output Request to send
2 DTR Output
TOD Output for PTP applicaons
Data terminal ready
Time of day for Precision Time
Protocol (PTP). You can use DTR pins
as a TOD universal asynchronous
receiver/transmier (UART) by using
breakout cables.
3 TxD Output Transmit data
4 Signal Ground Signal ground
5 Signal Ground Signal ground
6 RxD Input Receive data
7 DCD Input
TOD Output for PTP applicaons
Data carrier detect
Time of day for PTP. You can use DCD
pins as a TOD UART by using breakout
cables.
8 CTS Input Clear to send
USB Port Specicaons for the MX10004 Router
The following Juniper Networks USB ash drives are tested and supported for the USB port in the
MX10004 router:
• RE-USB-1G-S—1-gigabyte (GB) USB ash drive
• RE-USB-2G-S—2-GB USB ash drive
102