Juniper MX10004 - MX10004 Switch Fabric Board Maintenance

3. Grasp the fan tray controller and pull it straight out of the slot. See Figure 73 on page 172.
Figure 73: Remove the JNP10004-FTC2 Fan Tray Controller
4. Place the fan tray controller in an anstac bag or on an anstac mat.
MX10004 Switch Fabric Board Maintenance
IN THIS SECTION
How to Handle and Store MX10004 Switch Fabric Board | 173
Install an MX10004 Switch Fabric Board | 175
Remove an MX10004 Switch Fabric Board | 180
Each Juniper Networks MX10004 router contains a minimum of three and a maximum of six JNP10004-
SF2 Switch Fabric Boards (SFBs). These boards are installed vercally, mid-chassis, between the line
172