3. Grasp the top and boom handles and pull the fan tray out about 3 in. (7.6 cm). See Figure 69 on
page 168.
Figure 69: Remove an MX10004 Fan Tray
4. Tilt the top of the fan tray forward.
5. Using both hands, li the fan tray out of the slot and rest it on a at surface with the handles to the
side.
Install an MX10004 Fan Tray Controller
For each of the two fan trays, there is a JNP10004-FTC2 fan tray controller. Each controller is a hot-
removable and hot-insertable eld-replaceable unit (FRU); you can remove and replace one fan tray
168
To Next Page
Loading...
