Juniper MX10004 - Install a JNP10 K-PWR-DC2 Power Supply

CAUTION: Use the same type of power supply in all slots. Do not mix AC and DC
power supplies in a producon chassis.
Install a JNP10K-PWR-DC2 Power Supply
Before you install a JNP10K-PWR-DC2 power supply in the chassis:
• Ensure that you follow all safety warnings and cauons.
WARNING: Before performing DC power procedures, ensure that power is removed
from the DC circuit. To ensure that all power is o, locate the circuit breaker on the
panel board that services the DC circuit, switch the circuit breaker to the o (O)
posion, and tape the switch handle of the circuit breaker in the o posion.
WARNING: Protect yourself from severe burns by wearing heat-protecve gloves
when removing a working JNP10K-PWR-DC2 power supply from the chassis.
JNP10K-PWR-DC2 power supplies can reach temperatures from 158° F to 176° F
(70° C to 80° C) under running condions.
CAUTION: Before you connect power to the router, a licensed electrician must aach
a cable lug to the grounding and power cables that you supply. A cable with an
incorrectly aached lug can damage the router (for example, by causing a short circuit).
CAUTION: Use the same type of power supply in all slots. Do not mix AC and DC
power supplies in a producon chassis.
CAUTION: To meet safety and electromagnec interference (EMI) requirements and to
ensure proper operaon, you must connect the MX10004 routers to earth ground
before you connect them to power. For installaons that require a separate grounding
154